Sounds like a permission problem to me.
Make sure you have permission to write to the directory where the config files
are saved. Sorry I cannot look at my setup to see where that directory/file is
located.
I run N1MM+ one two win10 machines with no problem.
Mike
NA6MB
Sent from my iPad
> On Feb 4, 2017, at 2:14 PM, Lee Roberts <ham@n0sq.us> wrote:
>
> I don't know what the problem is but I can't reliably run N1MM in
> Windows 10. For some reason, it occasionally starts up with no
> configuration and I basically have to start from scratch. It asks for a
> new or existing database and proceeds to ask me to configure my station
> (i.e. callsign, grid, ARRL section, etc). Then I have to go into the
> menus and set up the rig and other parameters again. This is a major
> hassle if I shut down for a couple a of hours and then have this happen
> again. This doesn't happen when I run it under Windows XP.
> _______________________________________________
> RTTY mailing list
> RTTY@contesting.com
> http://lists.contesting.com/mailman/listinfo/rtty
_______________________________________________
RTTY mailing list
RTTY@contesting.com
http://lists.contesting.com/mailman/listinfo/rtty
|