> I have two ICOM radios (781 & 706) tried to run them on one serial port
> through Icom CI-V interface. Defined ser port for radio 1 nad 2 used
> different ddresses for ICOM radios, but TR program goes back to C:\ prompt
> while booting.
There should be an error message about using a port for two functions.
> Is it possible to run two (or more icom) radios on one ser port like
> that? If so, what has to be done/configured?
No, this has not been implemented - you need to use two serial ports.
Tree N6TR
--
FAQ on WWW: http://www.contesting.com/trlogfaq.html
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Sponsored by: Akorn Access, Inc. & N4VJ / K4AAA
|