NY4I wrote:
>
>Does anyone have a source for the connector on the back of the MFJ voice
>keyer? Or should I just buy it from MFJ? Also, someone had a schematic for
>using it with TR. Is it is around, could I get a copy of it.
Hello Tom,
The connector is called type MTA (by AMP) and uses a special tool to
press the wires into the back of pins in the connector body. They can
probably be pushed in with a small screwdriver, but I've never tried.
I have a handful of the 8-pin connectors and the tool, and some 7
conductor double shielded cable (foil and braid), only 7 pins are used on
the DVK connector.
I've used it to make an optically isolated interface for TRlog to key the
MFJ-434 DVK, putting 3 ft of cable on the DVK end and 2 feet on the PC end
(using the end of a 25-pin printer cable) with the circuit in a metal
mini-box in the middle.
If anyone wants one, I can put the MTA connector on a 3 ft piece of the
shielded cable and mail it in a padded envelope for $5.00. Either the MFJ
schematic (using transistors) or opto-couplers can be used for an
interface, I'll put a schematic of mine on my web site in a few days. The
pinouts for TRlog are shown in the back of the TRlog manual.
73 - Glenn
----------------------------
"Remember, any tool can be the right tool!" Red Green
AEØQ / V31RY ex: GM5BKC, ZB2WZ, SVØWY, WAØVPK
v31ry@ix.netcom.com --SOWP 5558-M, ARRL LM, QCWA LM, NCVA--
http://www.qsl.net/ae0q/
--
FAQ on WWW: http://www.contesting.com/FAQ/trlog
Submissions: trlog@contesting.com
Administrative requests: trlog-REQUEST@contesting.com
Problems: owner-trlog@contesting.com
Feature Wishlist: http://web.jzap.com/n6tr/trwish.html
|