TenTec
[Top] [All Lists]

[TenTec] Omni C / Corsair Hssssss.

To: <tentec@contesting.com>
Subject: [TenTec] Omni C / Corsair Hssssss.
From: edn4pk@vol.com (Ed & Edna)
Date: Tue, 1 Feb 2000 18:02:07 -0500
I talked to Paul at TT just yesterday about the same problem. His suggestion
was to add a 10 ohm resistor across the jack and a 100 ohm in series. There
is a 100 ohm in series inside the Corsair and OmniV, so you would have a T
pad. I use a pair of Telex and this still was not enough, at present I am
using a 1K in series. His other suggestion was a pair of 600 ohm headsets,
this might be a better solution especially if you operate CW. I make use of
the Tone control, Notch, and BP settings on my OmniV to control the hiss. I
also ride the RF Gain quite a bit. My .02 cents
Ed W3NR
Chickamauga,Ga.



--
FAQ on WWW:               http://www.contesting.com/tentecfaq.htm
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com
Search:                   http://www.contesting.com/km9p/search.htm


<Prev in Thread] Current Thread [Next in Thread>