TenTec
[Top] [All Lists]

[TenTec] Omni 6+ Question

To: <tentec@contesting.com>
Subject: [TenTec] Omni 6+ Question
From: rich@w3zj.com (Richard B Drake)
Date: Mon, 19 Mar 2001 22:58:40 -0500
I noticed that happening when I had the 10 minute ID warning
enabled. If I happened to be spinning the dial when the warning
sounded, it would cause a hesitation in the display as you
described. I finally decided that I wasn't able to hear the
warning at most times when I needed it anyway so I turned it off.

----
73, Rich - W3ZJ

> -----Original Message-----
> From: owner-tentec@contesting.com
> [mailto:owner-tentec@contesting.com]On
> Behalf Of J. Duffy Beischel
> Sent: Monday, March 19, 2001 18:24 PM
> To: tentec reflector
> Subject: [TenTec] Omni 6+ Question
>
>
>
> O.K., those of you with the experience, what is going
> bad or wrong when you
> turn the tuning knob quickly and the frequency changes,
> but occasionally
> stops with the last digit flashing a bit but then it
> starts going again?
> Has not really failed yet, but it is an annoyance.
>
> Regards,
>
> Duffy - WB8NUT
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>