TenTec
[Top] [All Lists]

[TenTec] INRAD 2.8's and RX Mod?

To: <tentec@contesting.com>
Subject: [TenTec] INRAD 2.8's and RX Mod?
From: paulc@mediaone.net (Paul Christensen)
Date: Fri, 22 Jun 2001 10:01:25 -0400
The Omni Six (Six +) receive mod can be accomplished by making the following
changes to the IF/AF Amp Board:

1) Replace C3 & C29 with 0.01 uF film capacitors (>50 VDC).
2) Replace R38 with a 680K-ohm resistor.

Depending on the vintage of your Omni Six, these components may be
surface-mount types (SMD).  Mouser is a great source for these components:

http://www.mouser.com/

To take full advantage of this mod, the 2.4 kHz filters in both IF slots
should be changed to the INRAD 2.8 kHz series.

http://www.qth.com/inrad/

-Paul, W9AC

----- Original Message -----
From: "Mike & Lara Pagel" <pagel@wi-net.com>
To: <tentec@contesting.com>
Sent: Friday, June 22, 2001 9:32 AM
Subject: [TenTec] INRAD 2.8's and RX Mod?


>
> Hello, all!
>
> I've saved enough to purchase a pair of INRAD 2.8 SSB filters, but I'm
> mulling it over and am looking for some feedback.
>
> The INRAD $15 RX mod has not, as I recall, received much attention here.
> Someone was going to post results but I don't think I ever saw it and the
> discussion has eluded me in the archives.
>
> My understanding is that the INRAD 2.8 SSB filters improve RX audio
quality
> without sacrificing selectivity.  It is also my understanding that the
INRAD
> RX mod enhances this feature, but that the RX mod is pointless without the
> INRAD filters being there to start with.
>
> Am I interpreting previous discussions correctly?  Does anyone have
> feedback?  I'd appreciate comments and/pr suggestions.
>
> Thank you, in advance, for your input!
>
> 73, de Mike, K9UW
> Amherst, WI
>
>
> --
> FAQ on WWW:               http://www.contesting.com/FAQ/tentec
> Submissions:              tentec@contesting.com
> Administrative requests:  tentec-REQUEST@contesting.com
> Problems:                 owner-tentec@contesting.com
>


--
FAQ on WWW:               http://www.contesting.com/FAQ/tentec
Submissions:              tentec@contesting.com
Administrative requests:  tentec-REQUEST@contesting.com
Problems:                 owner-tentec@contesting.com


<Prev in Thread] Current Thread [Next in Thread>