TenTec
[Top] [All Lists]

Re: [TenTec] OMNI VI+ Logic Board

To: <tentec@contesting.com>
Subject: Re: [TenTec] OMNI VI+ Logic Board
From: "Joe Simpkins" <K4MD@carolina.rr.com>
Reply-to: tentec@contesting.com
Date: Sat, 4 Sep 2004 17:50:58 -0400
List-post: <mailto:tentec@contesting.com>
Thanks, Chuck and all for the answer!!!

73,

Joe K4MD


----- Original Message ----- From: "Chuck (Jack) Hawley" <c-hawley@uiuc.edu>
To: <tentec@contesting.com>
Sent: Saturday, September 04, 2004 4:37 PM
Subject: RE: [TenTec] OMNI VI+ Logic Board



The pictorial is right. The un-plugged into pin is the rearmost (to the rear
of the radio) pin outside of 34...the two connectors are tight together.
Chuck KE9UW


-----Original Message-----
From: tentec-bounces@contesting.com
[mailto:tentec-bounces@contesting.com]On Behalf Of Joe Simpkins
Sent: Saturday, September 04, 2004 9:28 AM
To: tentec@contesting.com
Subject: [TenTec] OMNI VI+ Logic Board


Would there be anyone on this reflector that might help me determine a plug and pin configuration? After removing the 4 screws of the top of this radio, one can see the logic board on the right hand side of the radio facing you. There is a 6 pin header on this logic board that receives connectors labeled 41A and 34. Connector labeled 41A is a 3 pin connector and 34 is a 2 pin connector. The receiving header on the Logic Board is a 6 pin header, thus leaving 1 pin unaccounted for. The pictorial in the manual is not clear which pin on the Logic Board header is NOT connected by either of the 41A or 34 connectors. By the general convention of the other headers and connectors and review of the pictorial on page 4-19, it would seem that the two connectors are tight against one another leaving the empty pin outside the connector 34. I would not dare apply power to the radio until I am certain of the proper connection.

This seems to be the only void in the information from the
manual. The Logic
Board must be removed to install the TCXO daughterboard from TT.

Thanks for any help!

73,

Joe K4MD

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.745 / Virus Database: 497 - Release Date: 8/27/2004

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>