TenTec
[Top] [All Lists]

Re: [TenTec] Alignment tools for Omni 6 Plus

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Alignment tools for Omni 6 Plus
From: "Lew" <ljl160@verizon.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Fri, 14 Apr 2006 12:30:42 -0400 (Eastern Daylight Time)
List-post: <mailto:tentec@contesting.com>
Hi Don-Well, its slightly off frequency and it has a little carrier on lsb
(although I op 90+% CW). My friend is a ham and high end microwave tech with
a very expensive spectrum scope so I thought I would check out everything
while the opportunity arises 73 Lew 
 
-------Original Message-------
 
From: ve1bn@ns.sympatico.ca
Date: 04/14/06 10:38:27
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Alignment tools for Omni 6 Plus
 
Lew -
 
Why do you have to align your OMNI 6+?  What is wrong with it that you feel
you must?
I'm just curious.....
 
  73,  Don
 
 
----- Original Message -----
From: "Lew" <ljl160@verizon.net>
To: <tentec@contesting.com>
Sent: Friday, April 14, 2006 10:52 AM
Subject: [TenTec] Alignment tools for Omni 6 Plus
 
 
>I am going to check alignments on my Omni 6 Plus. A tech friend is helping
>so before I take the rig over to him,  does anyone know what alignment
>tools I need? type and sizes etc?? Covers have not been off this awesome
>rig!! Thanks-73-Lew K1NDV
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
 
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>