I notice the same on this end....Paragon II, 238B atu and MFJ-259B analyzer.
Also, my Mirage MP-2 wattmeters indicate a different power output reading
from the rig and atu if other than full power output from the Paragon II.
----- Original Message -----
From: <ARDUJENSKI@aol.com>
To: <tentec@contesting.com>
Sent: Wednesday, August 09, 2006 7:45 AM
Subject: [TenTec] Paragon II and SWR meter reading
>I noticed that not in all cases will the meter (set to SWR) in the Paragon
> II read exactly the same as that is the 238 ATU. By the way the 238 and
> the
> Paragon are connected by an 18 inch quality jumper (Belden 8214).
>
> I found a discussion on the topic in the ARCHIVES at
> _http://lists.contesting.com/archives//html/TenTec/2003-01/msg00663.html_
> (http://lists.contesting.com/archives//html/TenTec/2003-01/msg00663.html)
>
> Basically this section in short says to believe the meter in the rig.
>
> SITUATION: I did notice that if I turn the AGC button to OFF the meter
> will
> match the ATU meter. (By the way I use a MFJ 249 Analyzer to find the
> settings for the ATU but find in some cases it still needs to be tweeked
> when I
> push TUNE.) Is this normal? I could not find anything in the manual that
> even
> mentions the AGC in conjunction with operation of the SWR/TUNE set up.
>
> Is this normal or do I have a problem I need to look into?
>
> Thank you
>
> Alan KB7MBI
> Woodinville, WA
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|