I should have mentioned that I am using a microHAM microKEYER interface but
I have used this interface and directly connecting the serial cable from PC
to Orion II with the same result. I appreciate the responses from everyone
even the things I may have already tried.
I must say when the rig is work as it should it is amazing but when it acts
quirky it gets frustrating quick, especially at these prices.
Thanks for everyone's help and responses,
David, N4IN
-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Don Prater
Sent: Sunday, October 08, 2006 8:43 PM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Orion II firmware problems
No problem here with DX4WIN and O II and FW 2.037J.
73 Don
----- Original Message -----
From: "David E. Shelton" <des.n4in@gmail.com>
To: <tentec@contesting.com>
Sent: Sunday, October 08, 2006 7:46 PM
Subject: [TenTec] Orion II firmware problems
> Is it just me or does the current version of FW 2.037j have some issues
> with
> computer interfacing the Orion II. I can't get DX4WIN, MixW, WriteLog, or
> several others to interface smoothly with 2.037j. I reverted back to 2.034
> and the problems are gone. When will this be fixed? I looks like the FW
> was
> released September 7. This is a fairly significant problem that would
> affect
> about everyone with these rigs. Is there a work around other than using
> 2.034? Thanks,
> David, N4IN
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|