I've noticed the effect too Barry, also on SSB. To my ears, it sounds like
the DSP is just starting to overload.
I remain at 1.373b5.
73
Bob, 5B4AGN
----- Original Message -----
From: "Barry Gross" <barry.n1eu@gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, November 06, 2006 12:29 PM
Subject: [TenTec] Received cw sigs (2.059)
> Has anybody else noticed slight distortion (clipping) on stronger
> received cw signals with Orion 2.059? I tried hard to eliminate the
> distortion by adjusting RF versus AF gain and AGC but was
> unsuccessful. Using a new Heil ProSet. Any suggestions?
>
> Sometimes I wonder, as Duane recently did, whether there might not be
> a difference in Orion hardware that could account for the differences
> Orion owners are observing with 2.059. On the other hand, the
> receiver gain distribution seems to have changed dramatically in 2.059
> and perhaps the level match between dsp and audio chain was different
> (better?) in v1.
>
> Thanks & 73,
> Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|