TenTec
[Top] [All Lists]

Re: [TenTec] 6M with HF

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 6M with HF
From: "W5JMW John" <w5jmw@cableone.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 22 Feb 2007 20:21:40 -0600
List-post: <mailto:tentec@contesting.com>
actually the dual vfo's came on the cosmophone,hallicrafters had the fpm 
200.But I think it was a johnson,avenger maybe,probebly wrong that was 
first.The hallicrafters sr-400 with the remote vfo gave ham radio dual 
receive.It didnt go over then,oh well go figure..hi
----- Original Message ----- 
From: "John Geiger" <johngeig@yahoo.com>
To: <roncasa@verizon.net>; "Discussion of Ten-Tec Equipment" 
<tentec@contesting.com>
Sent: Thursday, February 22, 2007 8:00 PM
Subject: Re: [TenTec] 6M with HF


> Now I could be wrong (it has been known to happen),
> but I think the first radio with a built in Keyer was
> the Yaesu FT901DM, and the first rig with a built in
> antenna tuner was the Kenwood TS930SAT.  And the first
> rig with a memory channel was also the Yaesu FT901DM.
> Can anyone correct that?
>
> 73s John W5TD
>
> --- ron <roncasa@verizon.net> wrote:
>
>>> U S of A came out out with all solid state, first.
>> I do not remember about solid state memory keyers,
>> but didn't
>> Heathkit come out with them before JA?
>>
>>
>
>
>
> ____________________________________________________________________________________
> Any questions? Get answers on any topic at www.Answers.yahoo.com.  Try it 
> now.
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.446 / Virus Database: 268.18.3/697 - Release Date: 2/22/2007 
> 11:55 AM
>
> 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>