Volker,
My 961 ON/OFF rocker switch went kaputt a few years ago. I couldn't get the
power supply to turn ON after that happened. I purchased a replacement from TT
and installed it. Then it worked just fine again. So the switch can fail.
Thomas - AC7A
---- DJ2DW <DJ2DW@gmx.de> wrote:
> Dear Sirs,
> I have a problem with my power supply Model 961. The power supply is
> dead, no LED illumination at the front panel, no 13.8 VDC output, the
> two fuses at the rear inside and outside are ok.
>
> Therefore I am looking for a readable photostat copy of the circuit or
> manual.
>
> I have bought the 961 together with the 562 (omni 5) in March 1991
> without any circuit or handbook and no trouble until now. The 562 seems
> to be ok for its running properly with an Icom PS 15.
>
> Is there any ham who may have the circuit or component layout of the
> power supply 961 and may make it available to me ?
>
> Volker Kettling, DJ 2 DW, Dellwig 2 b, D 45549 Sprockhoevel
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|