I had a similar problem early on with my power supply. It turned out
that the cord going from the AC to the power supply had an internal
problem with the metal sleeves. I unplugged it, pulled the metal
sleevess out a bit with some needlenose pliers, and all was fine.
Look at ur power cord!
Neal Campbell K3NC
nealk3nc@gmail.com
telnet to our DX Spotting clusters at: dxc.k3nc.com, ports 12001 and 23
"Devoted to Dogs: How to be your dog's best owner"
Great Dog Book at www.abrohamneal.com
On May 30, 2007, at 4:36 PM, Roy wrote:
> "I have a problem with my power supply Model 961. The power supply is
> dead, no LED illumination at the front panel, no 13.8 VDC output, the
> two fuses at the rear inside and outside are ok...(etc.)"
>
> Perform some preliminary, basic tests. Do you read about 20 vdc
> across the
> basic filter caps? Try to localize the problem. Maybe even the
> power switch
> is defective (or your wall outlet!!).
>
> Good luck & 73,
>
> Roy K6XK
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|