| To: | "Discussion of Ten-Tec Equipment" <tentec@contesting.com> |
|---|---|
| Subject: | Re: [TenTec] 961 problem |
| From: | "Roy" <royanjoy@ncn.net> |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Wed, 30 May 2007 15:36:48 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
"I have a problem with my power supply Model 961. The power supply is dead, no LED illumination at the front panel, no 13.8 VDC output, the two fuses at the rear inside and outside are ok...(etc.)" Perform some preliminary, basic tests. Do you read about 20 vdc across the basic filter caps? Try to localize the problem. Maybe even the power switch is defective (or your wall outlet!!). Good luck & 73, Roy K6XK _______________________________________________ TenTec mailing list TenTec@contesting.com http://lists.contesting.com/mailman/listinfo/tentec |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] Question about O 1, Arthur |
|---|---|
| Next by Date: | Re: [TenTec] 961 problem, Neal Campbell K3NC |
| Previous by Thread: | [TenTec] Question about O 1, David E. Gilbert |
| Next by Thread: | Re: [TenTec] 961 problem, Neal Campbell K3NC |
| Indexes: | [Date] [Thread] [Top] [All Lists] |