I also had a "noise only" sub receiver in my O2. I thought perhaps I had a
weird setting on some parameter, but I was stumped. I sent it back to the
factory, and they could find nothing wrong, and suggested I didn't have an
antenna connected to the sub receiver ( incorrect assumption). It worked fine
when I got it back. However, this weekend, it happened again. Unlike the last
time, where I cycled the power, master reset and super-secret reset with a T-T
tech over the phone, this time cycling the power fixed the problem.
I did learn one thing. It would be cheaper to drive down there with it the next
time it quits.
Paul WB2ABD
(previous posts)
had a similar problem once - the sub-receiver would work only
intermittently and when in the failed state generated a harsh noise.
After trying master reset etc. I finally "fixed" it by re-seating the
sub-receiver board and all of it's cable terminations and have had no
trouble since (2 years ago). It might be worth trying if all else
fails.
Bob NW8L
On 10/13/07, G.C. <g.crosta at tin.it> wrote:
>
> Dear all,
>
> I want to submit a problem occurred to my Orion I transceiver.
>
> The radio has installed the firmware version 2.062a with the v2 hardware
> modification to the Logic/DSP board.
>
> I haven't any problems with the radio since last week but now the
> sub-receiver seems dead and I listen only a bad noise.
>
> I realized that because the SPLIT function was ON and I don't listen nothing
> on one ear.
>
> I have re-loaded the software and initially the radio seems to work properly
> but after I switched off it the sub-receiver doesn't work at all.
>
> Nothing happen after a Master reset or Ram clear.
>
> So, I don't know what happen and I would like to know what I should do.
>
> Could you help me please? May I have a suggestion from your side? Did it
> already happen to anybody else?
>
> I thank you in advance for your attention.
>
> Best regards,
>
> Giuseppe CROSTA IZ2ABU
>
> P.S. I submitted this message also to Ten Tec service and I hope to receive
> some info from Paul.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|