i have found that setting the port speed to 57,600 is the most important
setting once the proper port is chosen. i have used both serial and serial
to USB adapter with no change in operation. most software defaults to 8-n-1.
jack
ak7o
----- Original Message -----
From: "Ron Castro" <ronc@sonic.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Sunday, 05 April, 2009 11:45 AM
Subject: Re: [TenTec] ORION II latest version 2.04 failure to load
> Most of these problems are in the COM port of your computer. Are you
using
> an RS-232 serial port on the computer or serial-to-USB adaptor? In any
> case, check your Device Manager, make sure you have the right COM port
> selected, and set it to 57,600 8-N-1. Re-boot everything and start over.
> Ron N6IE
> www.N6IE.com
>
> ----- Original Message -----
> From: "dbp tds.net" <dbp@tds.net>
> To: "Tentec reflector" <tentec@contesting.com>
> Sent: Sunday, April 05, 2009 10:13 AM
> Subject: [TenTec] ORION II latest version 2.04 failure to load
>
>
> > Hi-
> > Not having any success loading the new version 2.04XL for the ORION II.
It
> > will get to load to line 10 of 5012 and halt at that point.
> > Currently I'm running version 2.039 and DSP2.016b14 so I think the
loader
> > program is up to date.
> > I have been off line so would have missed updates since early March.
> > Any suggestions?
> >
> > Dave
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> >
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|