Can't disagree with that Gary.
I was running a Corsair-1 when I bought the JST135 and at that time was into
Clover demanding a high degree of frequency stability which the Corsair
could not handle but the 135 did comfortably from immediate switch on and
still does.
73 de Malcolm
----- Original Message -----
From: "CSM(r) Gary Huber - AB9M" <glhuber@msn.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Thursday, February 25, 2010 8:52 PM
Subject: Re: [TenTec] Omni 6 plus chirp on 30 meters
> Regarding the Corsair II and PSK-31. I don't have any problems using my
> last production run Corsair II on PSK-31. What drift there is from cold
> start to stable is about 200 Hz over twenty minutes.
>
> http://www.csm-gh.com/AB9M-Shack.htm
>
> 73,
>
> Gary - AB9M
>
> --------------------------------------------------
> From: "Malcolm McLeman" <malcolm.mcleman@free.fr>
> Sent: Thursday, February 25, 2010 12:51 PM
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Subject: Re: [TenTec] Omni 6 plus chirp on 30 meters
>
>>
>> ----- Original Message -----
>> From: "Malcolm McLeman" <malcolm.mcleman@free.fr>
>> To: "Walt Amos" <waltk8cv4612amos@att.net>
>> Sent: Thursday, February 25, 2010 7:40 PM
>> Subject: Re: [TenTec] Omni 6 plus chirp on 30 meters
>>
>>
>>>
>>> Perhaps I should have said the second hand price arena looking recently
>>> at
>>> $675 for Corsair2 plus VFO as an example.
>>> My input was not intended to evoke an "us and them" scenario or digress
>>> into the world of car manufacture but now you mention it my trusty 1983
>>> (GM) Opel Ascona
>>> is still running on it's original Koyo wheel bearings.
>>> Due to the fact my Corsair is not stable enough for PSK31 my second rig
>>> is
>>> a JRC JST135, slated by QST on its debut and not necessarily everyones
>>> cup
>>> of tea, I find as solid as a rock.
>>> I think Ten Tec are very lucky to have such a faithful following, myself
>>> one of them.
>>> My point was very expensive rigs whatever their origin that chirp
>>> require
>>> constant tweaking or (and only what I read) in the case of the Orion
>>> unfulfilled software I find unacceptable.
>>> 73
>>> Malcolm F5VBU
>>>
>>>
>>>
>>> ----- Original Message -----
>>> From: "Walt Amos" <waltk8cv4612amos@att.net>
>>> To: "Malcolm McLeman" <malcolm.mcleman@free.fr>
>>> Sent: Thursday, February 25, 2010 7:00 PM
>>> Subject: Re: [TenTec] Omni 6 plus chirp on 30 meters
>>>
>>>
>>>> First off, they are not in the same price range, the OMNI, even new was
>>>> half the cost of the other ones you mention. Secondly, all, and let me
>>>> say that again, ALL , radio equipment have / has problems! The first
>>>> YAESU FT-1000MP I go worked for about 20 seconds and then went DEAD!
>>>> The
>>>> dealer actually had to talk to YAESU to get permission for me to send
>>>> it
>>>> back, Chip Margelli was the CEO then and gave them permission. The
>>>> second
>>>> one worked fine for many years but now the RIT control is
>>>> malfunctioning
>>>> and probably just a dirty plug on what ever board it is connected to
>>>> and
>>>> will eventually get around to opening it up and fixing it! Kenwood is
>>>> now
>>>> almost out of business because of the rotten rice boards and the plated
>>>> through hole going open! Look at the problems TOYOTA is having and
>>>> KILLING PEOPLE ! You can't believe in any STUFF ...............
>>>>
>>>> :-)
>>>>
>>>> Walt K8CV Royal Oak, MI.
>>>>
>>>>
>>>> ----- Original Message -----
>>>> From: "Malcolm McLeman" <malcolm.mcleman@free.fr>
>>>> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
>>>> Sent: Thursday, February 25, 2010 12:47 PM
>>>> Subject: Re: [TenTec] Omni 6 plus chirp on 30 meters
>>>>
>>>>
>>>>> As I almost went down the Omni 6 plus road do I read correctly that a
>>>>> modern
>>>>> transceiver competing in the same price arena as the Icom Pro or the
>>>>> FT
>>>>> 1K
>>>>> series not only chirps but requires regular tweaking?
>>>>> 73 Malcolm F5VBU
>>>>>
>>>>> ----- Original Message -----
>>>>> From: "donhall161" <donhall161@sbcglobal.net>
>>>>> To: <ken.d.brown@hawaiiantel.net>; "Discussion of Ten-Tec Equipment"
>>>>> <tentec@contesting.com>
>>>>> Sent: Thursday, February 25, 2010 2:57 PM
>>>>> Subject: Re: [TenTec] Omni 6 plus chirp on 30 meters
>>>>>
>>>>>
>>>>>> Did that and check again regularly.
>>>>>>
>>>>>>
>>>>>> 73 Don K5AQ
>>>>>> _______________________________________________
>>>>>> TenTec mailing list
>>>>>> TenTec@contesting.com
>>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>>>
>>>>>
>>>>>
>>>>> _______________________________________________
>>>>> TenTec mailing list
>>>>> TenTec@contesting.com
>>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>>
>>>>
>>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|