pins 1 and 2 are shorted for heaters..it is shown in the book..73 john
----- Original Message -----
From: <BUDW2GLN@aol.com>
To: <tentec@contesting.com>
Sent: Tuesday, March 29, 2011 4:34 PM
Subject: [TenTec] FT-901DM question
> If anyone in this forum happens to have a FT-901DM transceiver. I have
> a
> question about the Accessory Plug
>
> The manual shows the plug and where it goes (no brainer) and it is shown
> in
> the "Connection Diagram"
>
> According to the manual, if the accessory socket is not used for any of
> the
> accessories, this plug is needed to complete the Heater Circuit for the
> three output tubes (Driver & two finals) NOW, I don"t have the physical
> plug..
>
> I can build one but there is no diagram for it......I need to know how the
> plug is wired :-)
>
> Can anyone help me :-).........Is there a Yaesu forum
>
> 73
>
> Bud, W2GLN
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
--------------------------------------------------------------------------------
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.894 / Virus Database: 271.1.1/3537 - Release Date: 03/29/11
01:34:00
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|