On Fri, June 10, 2011 1:52 pm, Tom Stone wrote:
> Just an update - I have been informed by Paul at Ten Tec that even if you
> are able to adjust C16 on the TX Audio Board, so that the SSB "sounds"
> correct to your ear, "the SSB signal might not be centered in the filter
> passband causing distortion on the transmitted signal".
>
> Since I do not own a frequency counter, I am going to be sending my Omni
> VI+
> back to Ten Tec to have them check alignment in the LSB mode.
I was concerned whether the TX and RX were similarly aligned, or if one
could be off from the other.
My VX-7R has a built in frequency counter mode, but I have never had cause
to use it..
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|