How about a small fan from an old PC or other piece of equipment? A friend of
mine uses a small fan from a Cisco router (1"x1") at his desk.
Chris, K4RCH
-------
On Dec 10, 2011, at 17:18, Richards <jruing@ameritech.net> wrote:
> SEASON'S GREETINGS TEN TEC MAVENS...
>
> My question follows K7NSW's comment on reducing air flow through the
> Centurion. I built a stand to hold my Centurion amp below my desk, and
> it is placed so that there are at least 5 inches of space between it and
> the back and side of the desk shell. Still, it gets warm under there
> and I have used a small fan to move air out from behind and beside the
> amp where it is close to the desk shell.
>
> So... Does anyone have a clever idea as to how I might mount a smaller,
> yet sufficient, fan under the desk, maybe to run off my 12 volt power
> supply distribution system, that would not add noise, not add too much
> wind, and still move cooler air in and around the beast?
>
> The fan I have now, sits on the floor, and is way overkill for the job,
> adding both more noise and more air flow than necessary. So, I am
> considering a smaller, more appropriate solution.
>
> Any traction?
>
> Thanks loads. Happy Trails and Happy Holidays to all.
>
> ============================== James -K8JHR ================
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|