TenTec
[Top] [All Lists]

Re: [TenTec] OMNI VI+ Tuning Problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] OMNI VI+ Tuning Problem
From: John Oglesby <john91@charter.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 24 Sep 2012 18:27:05 -0400
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
It looks like there is a concensus. I'll give TT a call tomorrow. I'll let you 
know how it goes. 

73
John

Sent from my iPhone

On Sep 24, 2012, at 5:44 PM, "Jerry, N9AW" <n9aw@sbcglobal.net> wrote:

> John,
> I have an Omni VI + and was exhibiting some of the same issues.  It was a bad 
> main tuning encoder.  In my case, it worked fine when turning clockwise but 
> when turning counter-clockwise it would not change frequency between about 3p 
> and 9am (going backwards) on the knob.  I took it apart and cleaned all of 
> the connections to the front panel board.  The only fixed it a little.  It 
> then didn't work from 2p backwards to 10am.   In the end I sent it to TenTec 
> and they replaced the encoder and did the general tune up they do with all 
> rigs in for repair.  They warned me about the price ahead of time asked for 
> permission to proceed.  They said they had to totally disassemble the front 
> panel (all knobs and switches had to come off) in order to replace the 
> encoder.  Encoder cost was about $75 but the overall bill including return 
> shipping was just over $300.  I know....OUCH!.
> 
> Sorry to be the bearer of bad news John.
> 
> 73
> Jerry, N9AW
> 
> 
> ----- Original Message ----- From: "John Oglesby" <john91@charter.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Monday, September 24, 2012 4:02 PM
> Subject: [TenTec] OMNI VI+ Tuning Problem
> 
> 
>> I have an OMNI VI+ that is exhibiting VFO problems. Occasionally the main 
>> tuning will not change frequency, or will do so at a very slow rate, or in 
>> the wrong direction.  It is almost as if the main tuning knob is slipping on 
>> the shaft.  However, it isn't slipping.  This sometimes cures itself or 
>> sometimes when I change bands a few times.
>> 
>> I have not seen this reported previously as an issue.
>> 
>> Anybody have experience with this problem?
>> 
>> Thanks & 73
>> 
>> John
>> N9RE
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>