[TenTec] TCXO install

[Don Scippa <dscippa@gmail.com>]

Hi all,
New to the list. Just about to install the TCXO kit in the Omni 6 but 
the instructions seem a bit unclear.
It says to remove the cap(I assume this is C10) and connect the coax. 
What they failed to mention was where
the two leads get connected(center and shield). I could take out the 
whole board to trace it out but I thought
I would ask here and save myself a lot of work.

Thanks in advance

Don
K8EAA
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec