[TenTec] Transmit not stopping when PTT is released

[Rod Greene <w7zrc@yahoo.com>]

I just installed a new to me microKeyer II.  Trying to follow the setup 
instructions in the manual, I connected a mono cable (RCA plugs) between Amp 
Key 1 on the O2 and PTT IN on the mK2. When the O2 is keyed (via footswitch or 
VOX) the O2 stays in transmit when the foot switch is released. Only way to get 
the O2 out of transmit is to turn its power switch off. 

Is this controlled by a setting I may have missed? I've read through the manual 
until I'm blue in the face ... As long as I don't connect this cable between 
Amp Key 1 and PTT IN everything seems to work okay. 


Also - running the rig into a dummy load to eliminate RFI in the shack doesn't 
make any difference.

For now I'll just not connect this cable. Not sure I need it, but haven't yet 
tried the mK2 with N1MM or any other software.