Yea...back the power on the rig down to nothing, and see what happens!
....Dave
On 12/5/2013 5:51 PM, Carl Moreschi wrote:
Sounds like an RFI problem to me.
Carl Moreschi N4PY
58 Hogwood Rd
Louisburg, NC 27549
www.n4py.com
On 12/5/2013 5:43 PM, Rod Greene wrote:
I just installed a new to me microKeyer II. Trying to follow the
setup instructions in the manual, I connected a mono cable (RCA
plugs) between Amp Key 1 on the O2 and PTT IN on the mK2. When the O2
is keyed (via footswitch or VOX) the O2 stays in transmit when the
foot switch is released. Only way to get the O2 out of transmit is to
turn its power switch off.
Is this controlled by a setting I may have missed? I've read through
the manual until I'm blue in the face ... As long as I don't connect
this cable between Amp Key 1 and PTT IN everything seems to work okay.
Also - running the rig into a dummy load to eliminate RFI in the
shack doesn't make any difference.
For now I'll just not connect this cable. Not sure I need it, but
haven't yet tried the mK2 with N1MM or any other software.
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|