Update: The Master Reset did nothing except set all the setting to
default.
Paul suggested that the Offset Display Preference OdP in Menu 3 was perhaps
the problem. I played with that some this morning, When it is off, one
must use -.7 XIT to communicate with the 706 on 14,050.00. When OdP is ON,
the received frequency display changes with RIT one must use +.7 RIT to
communicate with the 706 on 14,050.00.
Somehow I doubt that Omni VI radios in normal use REQUIRED the use of
either RIT or XIT in CW.
Since I have no idea how to hook up or have the equipment to align the BFOs
or anything else, it looks like it's back to TenTec, although it might be
cheaper to sell this one to a no code SSB op and find another one.
73 de W6OGC Jim Allen
On Tue, Apr 29, 2014 at 6:23 AM, GARY HUBER <glhuber@msn.com> wrote:
> The SPOT button lets us zero beat...
>
> 73 & DX,
> Gary - AB9M
>
> -----Original Message----- From: Steve Hunt
> Sent: Tuesday, April 29, 2014 3:20 AM
> To: Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] Omni VI mystery
>
>
> Not for us Corsair owners ;)
>
> Steve G3TXQ
>
>
>
> On 28/04/2014 23:52, Brian Carling wrote:
>
>> With most transceivers, if you make sure that the signal you are
>> receiving is Tuned exactly to your side tone pitch then you will be on the
>> same frequency as them.
>>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|