| To: | tentec@contesting.com |
|---|---|
| Subject: | Re: [TenTec] Trading radios |
| From: | k4elo@fastmail.fm |
| Reply-to: | Discussion of Ten-Tec Equipment <tentec@contesting.com> |
| Date: | Sun, 01 Jun 2014 11:42:44 -0500 |
| List-post: | <mailto:tentec@contesting.com> |
Disagree Bob. Put the choke at the feedpoint of the antenna or your coax will be radiating rf all the way down to the rig. If you can't move the antenna, this is the most effective rfi fix. 73 Wayne K4ELO > For starters, as to RFI issues, yes antenna to radio spacing, increasing > same, will usually improve the issue. Be sure all equipment is each > bonded to a common point such as the PS ground. Omit the external > ground but keep 3rd pin ground intact. Use a common mode choke on the > output of the radio. > > 73 > Bob K4TAX |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [TenTec] trading Radio's again, David Perrin |
|---|---|
| Next by Date: | Re: [TenTec] Trading radios, Mike Schatzberg |
| Previous by Thread: | Re: [TenTec] trading Radio's again, David Perrin |
| Next by Thread: | Re: [TenTec] Trading radios, Mike Schatzberg |
| Indexes: | [Date] [Thread] [Top] [All Lists] |