Hello.
I would make certain that the ground connection is still true.
RF getting into the rig will mimic this behavior.
I would also check the power connector, the fuse and fuse holder.
This was a reason that I did the Molex to Power Pole conversion
six years ago. No problem since.
Fernando N2FQ/6
n2fq@sbcglobal.net
> On Nov 3, 2016, at 11:53 AM, Louis C Loria via TenTec <tentec@contesting.com>
> wrote:
>
>
> My Jupiter has a problem where it will act as though there is a power surge
> when I hit the transmit button.
>
> The screen on the Jupiter goes blank and I hear all the relays cycle and then
> I have to recycle the on-off
>
> switch and it comes back to life ok. Sometimes it will go for a couple of
> days without doing this and then
>
> it might do it two or three times in a day. Any ideas?
>
> Louis C Loria, W0QQG
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|