I need to amend my previous response. The encoder in the Jupiter is a
HRPG-ASCA#17F. That particular encode is the tough one to find. I ordered the
HRPG-ASCA#17C. Same shaft length, shaft diameter and resolution but different
mounting and connection to the circuit board.
Ripley
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
________________________________
From: TenTec <tentec-bounces@contesting.com> on behalf of Bob Ripley
<bob_ripley@hotmail.com>
Sent: Thursday, November 9, 2017 10:02:47 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Replacement VFO encoder for TT Jupiter
Correct.
Ripley
Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for Windows 10
________________________________
From: TenTec <tentec-bounces@contesting.com> on behalf of Barry N1EU
<barry.n1eu@gmail.com>
Sent: Thursday, November 9, 2017 9:58:59 AM
To: Discussion of Ten-Tec Equipment
Subject: Re: [TenTec] Replacement VFO encoder for TT Jupiter
Yes, but just to be clear (and it's already been mentioned) - that is an
adaptable part, not a direct replacement since the cabling/pin
configuration is different. A direct replacement is NOT available.
Barry N1EU
On Thu, Nov 9, 2017 at 9:38 AM, Bob Ripley <bob_ripley@hotmail.com> wrote:
> Yes sir, it is HRPG-ASCA#17C made by Avago (Now a part of Agilent) and
> sold by Newark Electronics, UK.
>
> The cost was less than $40.00 including shipping.
>
>
>
> http://www.newark.com/pdfs/datasheets/Avago/06B3710.pdf
>
>
>
>
>
> Ripley
>
>
>
> Sent from Mail<https://go.microsoft.com/fwlink/?LinkId=550986> for
> Windows 10
>
>
>
> ________________________________
> From: TenTec <tentec-bounces@contesting.com> on behalf of Curt Benjamin
> via TenTec <tentec@contesting.com>
> Sent: Thursday, November 9, 2017 9:11:09 AM
> To: Discussion of Ten-Tec Equipment
> Cc: Curt Benjamin
> Subject: [TenTec] Replacement VFO encoder for TT Jupiter
>
> Do you know what the mfg part number of the encoder is? My guess is that
> it will be a common, 128 or 256 PPR optical encoder with a 1/4" shaft. You
> should be able to find a new replacement on ebay for less than $50.
> Curt, K8AI
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|