TenTec
[Top] [All Lists]

Re: [TenTec] HELP! Eagle Tuning Problem

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] HELP! Eagle Tuning Problem
From: CBarutzki <cbarutzki@gmx.de>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 2 Jan 2020 07:53:35 +0100
List-post: <mailto:tentec@contesting.com>
Hello

I had similar problem after  i buyed used Eagle. The seller opened the Eagle to 
make some pictures. I had swr Problem on nearly all qrgs. The CW Sound  was 
disturbed. I opened the Eagle and reconected all Connections especialy the 
connections to Tuner. This was the Problem ! My Eagle works today like new.
Vy 73 and hny Chris de Df8wl 

Von meinem iPad gesendet

> Am 01.01.2020 um 20:59 schrieb Gary Follett <dukeshifi@comcast.net>:
> 
> Lots of good suggestions already posted.
> 
> Don’t overlook the possibility of a heat-induced failure of a capacitor or 
> anything else that could affect final amplifier or driver bias. Improper bias 
> can cause LOTS of harmonic distortion and, into a resonant load, presents a 
> high SWR. Try testing the radio, when it is acting up, into a resistive dummy 
> load to see if this kills the high SWR. Since the dummy load is not resonant, 
> the harmonics from the radio will not appear as reflected power so no 
> elevated SWR will be seen.
> 
> Gary
> 
> W0DVN
> 
>> On Jan 1, 2020, at 11:58 AM, Bob McGraw K4TAX <rmcgraw@blomand.net> wrote:
>> 
>> Yes, coax jumpers do go bad from all the wiggling and jiggling, connecting 
>> and disconnecting.   And some are just pure crap to start with.
>> 
>> Also any PL-259 must be more than finger tight.   I use a pair of 4" Channel 
>> Lock pliers to snug mine.   That solves many many problems.
>> 
>> I use my antenna bridge on 144 MHz and a dummy load to test my jumpers.   I 
>> wiggle, jiggle, pull and push.  If the SWR flickers, I chop the PL-259 off 
>> and start with a new piece of coax and a new connector.  It isn't worth 
>> trying to save a questionable connector or piece of coax.
>> 
>> 73
>> 
>> Bob, K4TAX
>> 
>>> On 1/1/2020 11:32 AM, Byron Cordes via TenTec wrote:
>>> Let’s hope for the best. Bad coax jumper Bad pl259 antenna , ground 
>>> connection on antenna . Do you have different antenna ?
>>> I just had a bad coax a few months ago.
>>> 73s Byron AC9PA
>>> 
>>> Sent from my iPad
>>> 
>>>> On Jan 1, 2020, at 11:13 AM, 1291jim@gmail.com wrote:
>>>> 
>>>> Happy New Year All,
>>>> 
>>>> I have had an issue with my Eagle happen twice now.
>>>> 
>>>> Issue:
>>>> -  Eagle loses tuning and SWR starts going crazy and jumping all over the
>>>> place
>>>> -  Will not tune with inboard or outboard tuner
>>>> -  Returns to normal operation after I shut in down for a while
>>>> 
>>>> Background:
>>>> - Has only happened when I have been operating for several hours and during
>>>> a 20 min+ QSO, (so lots of sending) and both times on 40M
>>>> - Eagle felt warm but not hot
>>>> - Antenna is an EndFed (Alpha Antenna J-Pole Sr)
>>>> - Without tuning on 40M SWR is 2.6 : 1
>>>> - Normally tunes to 1.0 or 1.1 : 1 with outboard or internal tuner
>>>> 
>>>> 1st occurrence:
>>>> - I had been operating for 3-4 hrs
>>>> - Eagle was running 100W through an MFJ Intellituner Model 993B that tuned
>>>> SWR to 1.1 : 1
>>>> - SWR started jumping all over the place
>>>> - MFJ could not tune it
>>>> - I assumed it was the MFJ Tuner, shut it all down.
>>>> 
>>>> 2nd occurrence: (last night)
>>>> - Had been operating several hours at 100W
>>>> - Eagle again through MFJ Tuner when SWR started jumping all over
>>>> - This time I bypassed the MFJ tuner and tried to tune with the Eagles
>>>> internal tuner
>>>> - The internal tuner could not tune the antenna and SWR continued going 
>>>> nuts
>>>> through the attempted tuning process
>>>> 
>>>> This morning after a rest, rig tunes FB with outboard or inboard tuner.
>>>> 
>>>> Pulling it from service now.
>>>> 
>>>> Any advice would be appreciated.
>>>> 
>>>> HNY ES 73 DE W6JIM
>>>> 
>>>> 
>>>> 
>>>> 
>>>> 
>>>> 
>>>> 
>>>> _______________________________________________
>>>> TenTec mailing list
>>>> TenTec@contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/tentec
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec@contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
<Prev in Thread] Current Thread [Next in Thread>