Hi Michael,
Here's the link to step-by-step instructions for replacing the Molex
connector with an Anderson Powerpole connector:
https://tentecwiki.eqth.net/doku.php?id=orion_molex_to_power_pole_mod
I used these instructions on my own rig and it worked fine. People have
strong opinions about the Powerpole connectors so this solution might not be
for everyone. All I can tell you is that the mod was done ~10 years ago
(I've sold the rig since then) but the new owner uses it daily and the
connector has been reliable.
73,
Mike, K9UW
Amherst, WI
-----Original Message-----
From: TenTec <tentec-bounces+k9uw=wi-net.com@contesting.com> On Behalf Of
Michael Tortorella via TenTec
Sent: Thursday, September 29, 2022 3:04 PM
To: tentec@contesting.com
Cc: Michael Tortorella <w2iy@verizon.net>
Subject: [TenTec] Orion power connector
What a headache. So much current flows that the Molex connector melts (yes,
probably because the pins are loose and not making good connection). Does
anyone have a suggestion for a better connector? I am going to scour my
collection of MIL-SPEC circular connectors to see if anything will fit. When
the connector lets go, it sounds like the entire radio is exploding, ugh.
TIA, 73, Mike W2IY
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|