Hi, All and Tom,
> What I find better is 10dB signal = 10dB audio change at noise floor
> becoming 10dB=1dB or less audio change at some higher level. It gets rid
of
> the "mush" or blend of signals and noise when the noise is somewhat even
but
> rough.
Ok. That is why I did not find much difference in my experiments - I can set
up the maximum gain and AGC threshold with the "RF Gain" control from
the front panel. The AGC is not acting on signals below threshold,
so 10dB input=10dB audio :) !
Thank you for the reply,
All the best !
Oleg
73 de UR3IQO
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|