Hello:
When I model a 70' Vertical with Capacity Wires that slope down from
each other at a 180 Degree From the Top, they show a nice clean Pattern
and Great op Loading.
But in Reality, I cannot get 180 Degrees, (top Hat wires Opposite of
each other), because of a Tree in One direction.
How much of a degradation of Pattern would I have if the top Hat wires
were 140 Degrees from each other? I think they still would provide
proper loading but what effect would they have on the Pattern and
efficiency or would I notice any difference?
Thanks, This will be a weekend Project.
Bruce N9BX
_______________________________________________
Topband mailing list
Topband@contesting.com
http://lists.contesting.com/mailman/listinfo/topband
|