I agree with Bob. When in Ayer Island, OC-177, 2007, I also used the KD9SV
transformer and performed very well indeed. FYI.
Jo, YC0LOW
On Tue, Sep 6, 2011 at 12:26 PM, ROBERT HARMON <k6uj@pacbell.net> wrote:
>
> KD9SV offers the transformer and 900 ohm resistor for the pennant antenna,
> ready to go, very inexpensive. I am using his kit and works great.
> It is stock number SV-PEN on his website: http://www.radiobooks.com/
>
>
> Bob
> K6UJ
>
>
>
>
>
>
> On Sep 5, 2011, at 3:10 PM, Hardy Landskov wrote:
>
> > I used 2--1800 ohm, 1 watt resistors in parallel. The resistance came out
> to
> > be 920 ohms but close enough to see that the F/B ratio was 25 db or so.
> > 73 Hardy N7RT
> >
> > ----- Original Message -----
> > From: <allan1@dejazzd.com>
> > To: <topband@contesting.com>
> > Sent: Monday, September 05, 2011 9:50 AM
> > Subject: Topband: Termination resistor for 160-80- Pennant antenna
> > (Receiveonly)
> >
> >
> >> The 160-80 pennant antenna calls for a 900 ohm termination resistor.
> >> Since 900 is not a standard resistor value, what is the best way to
> >> accomplish this? Not enough room for a beverage at this qth!
> >>
> >> Thanks
> >>
> >> Allan W2TN
> >> _______________________________________________
> >> UR RST IS ... ... ..9 QSB QSB - hw? BK
> >
> > _______________________________________________
> > UR RST IS ... ... ..9 QSB QSB - hw? BK
>
> _______________________________________________
> UR RST IS ... ... ..9 QSB QSB - hw? BK
>
_______________________________________________
UR RST IS ... ... ..9 QSB QSB - hw? BK
|