Topband
[Top] [All Lists]

Re: Topband: Beverages 2 basic questions

To: "Mike Waters" <mikewate@gmail.com>, "topband" <topband@contesting.com>
Subject: Re: Topband: Beverages 2 basic questions
From: "ZR" <zr@jeremy.mv.com>
Date: Sun, 2 Dec 2012 10:54:15 -0500
List-post: <topband@contesting.com">mailto:topband@contesting.com>
Mike, Im pretty sure a group buy would convince the manufacturer to sell them. Supposedly an Ebay seller has an "exclusive" but since our use is non competitive to his SWL and cave dweller ham customers it could be negotiated.

The large diameter steel ones work well but rust away in 15-18 months in this area of acid rain and salt water fogs. Using spray cans of Rustoleum, etc would be time consuming and likely needing periodic touchups. Plus the steel further slows down the incoming wave so it might not be possible to build an effective 1 wavelength + version. I had 5 stretched over about 175' and calculated a Vp of .57 but it sure worked gangbusters for those LP sunset signals over Africa. For many I was the only US station working them and the almost total lack of even EU QRM was a huge advantage. Switching to a 750' regular Beverage pointing right down the Med heard only a EU din; I'll let you estimate the F/S rejection of the Slinky.

Using a high frequency local BCB station right off the back the null was at 1250-1300 Ohms using a 2K pot and replaced with 3 x 3900 Ohm 2W carbon resistors. Id guesstimate the general F/B to be over 20dB on 160. My feeling is that performance could not be duplicated by various other loading methods. If somebody wants to make real world comparisons it might be beneficial.

Carl
KM1H




----- Original Message ----- From: Mike Waters
To: ZR ; topband
Sent: Saturday, December 01, 2012 2:41 PM
Subject: Re: Topband: Beverages 2 basic questions


Please let us know how that works, Carl. I'd love to experiment with a Slinky.

If brass Slinkys aren't available anymore, then we could wind one from some #14 or #12 solid copper wire using a long piece of plastic pipe as a form. Close-wind it first, then stretch it to the desired (?) pitch.

73, Mike
www.w0btu.com


On Sat, Dec 1, 2012 at 9:52 AM, ZR <zr@jeremy.mv.com> wrote:

Next year Im planning to try a couple of Slinky Beverages again in order to get a 2-3 wave electrical equivalent for particular paths and narrow the beamwidth





No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1427 / Virus Database: 2634/5430 - Release Date: 12/01/12
_______________________________________________
Topband reflector - topband@contesting.com

<Prev in Thread] Current Thread [Next in Thread>