Well, I don't think there is a "one-size" or "one--mix" "fits all" preferred
solution. I've wanted to try some 31 mix cores for common-mode isolation at
80 and 160. On the other hand, some of the Fair-Rite 71 (73?) material
toroids and binocular cores provide really good performance, even at lower
frequencies, because of the lower losses and better frequency response.
I also suspect that for power handling applications ( including common-mode
suppression), the 31 mix might have some heating issues, because of the
higher losses.
BTW, I do know from experience that the Fair-Rite 71/73 etc. mix higher
frequency cores seem to be impervious to weather! I have used the tubular
cores and large binocular cores out of doors for years as common mode chokes
on RG-213 for my 5-band quad feed-line and to make quick home-brew W2DU 1:1
current baluns for vertical dipoles for. 30 and 40 meters. I've never seen
any evidence of corrosion nor have I noted any performance degradation.
I've used the binocular transformer cores to construct matching transformers
for "KAZ" terminated receiving loops for 160.80.40 and 30 m and use a
larger binocular core to match 50 ohms up to the cathode impedance of my
home-brew 3-500ZG amp, to avoid having to install a much more complex
band-switch. Works quite well 160-10m and comfortably handles everything
that my FT-1000MP delivers.
Fortunately I had a good selection of cores in my Fair-Rite developer kits
from my engineering days!
73,
Charlie, K4OTV
-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Tom W8JI
Sent: Wednesday, August 06, 2014 3:09 PM
To: Ron Stordahl, AE5E; topband@contesting.com
Subject: Re: Topband: Ferrite Cores
In this discussion two different ferrite mixes are mentioned: #31 and #61.
>From the descriptions of these on the Fair-Rite web page, it appears that 31
would be more suitable for lower frequency applications. >>>>
Core selection can be fairly complex in transmitting systems. I've yet to
see a case where one core mix is the be all end all for the range of things
you run into in the field. Especially at high common mode impedances.
Receiving is a completely different story, because core stresses are always
low.
73 Tom
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|