One thing that W8JI clarified for me in winding binocular cores is what
is a "turn". Normally, a wire thru a toroid hole is a "turn". A
binocular core is two toroids in a single piece of ferrite. Tom
proposed calling a wire in one side of a binocular core a "pass" and
thru both sides a "turn". Thus, 2.5 "turns" are possible with 5
"passes". Usually, a "turn" by authors means 2 "passes" but there are
exceptions.
With the different windings coming out of opposite ends there will be a
little less stray coupling and it makes it easier to connect them to
their respective connectors. If there is no ground path between the
conductors then you have an isolation transformer which can reduce noise
pickup.
I use small watertight plastic boxes I found on ebay for all sorts of
receive antenna projects, very well made.
http://www.ebay.com/itm/Clear-Waterproof-Cover-Plastic-Electronic-Project-Box-Enclosure-CASE-85x58x33mm/201653764558?_trksid=p2047675.c100005.m1851&_trkparms=aid%3D222007%26algo%3DSIC.MBE%26ao%3D1%26asc%3D39007%26meid%3D1c6a2a52ecb446888faad4eadfecbe82%26pid%3D100005%26rk%3D3%26rkt%3D18%26sd%3D262605424625
If you use some 30ga insulated wire wrap wire, it is less fragile
against the ferrite and has a higher isolation voltage between the
windings than enamel insulation. A little RTV or hot melt keeps the
core secured to the box.
Grant KZ1W
On 9/27/2016 20:46 PM, Lee STRAHAN wrote:
Yes Ed, You have the right numbers. It won't matter which windings are first
or last. You can even wind 4 then wind 1 more and use it as an autotransformer
where the 1 turn is added to the 4 for 5. Any of these will work fine at these
TOP Band and higher frequencies. This ratio is not perfect but will work just
fine. It would be 50 to 78 ohms which in our world is close enough.
Let us know how your new 8 circle works. Maybe even compare it to your Hi-Z
4-square.
Lee K7TJR
-----Original Message-----
From: Topband [mailto:topband-bounces@contesting.com] On Behalf Of Ed Stallman
Sent: Tuesday, September 27, 2016 8:35 PM
To: topband@contesting.com
Subject: Topband: 75 ohm RG6 to 50 Ohm radio
My receive antenna is 75 Ohm RG6 connected to my radio and I want to wind a
2873000202 binocular core to step 75 to 50 Ohm's . I seen this info on W8JI web
page but can't seem to find it again.
I do remember it's 4 turns 50 Ohm and 5 turns 75 Ohm and all wires come out the
same side of the core . Am I correct so far?
Does it make a difference which winding I wind first ?
Thanks in advance , Ed N5DG
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
_________________
Topband Reflector Archives - http://www.contesting.com/_topband
|