Topband
[Top] [All Lists]

Re: Topband: FT8 on 160 - how you can make a difference

To: topband@contesting.com
Subject: Re: Topband: FT8 on 160 - how you can make a difference
From: Artek Manuals <Manuals@ArtekManuals.com>
Date: Sat, 3 Aug 2019 17:52:32 -0400
List-post: <mailto:topband@contesting.com>
Dave

If read your post correctly you are saying that you are working against an ambient noise level of 20-30 db over S9 is that correct.?

And for starters your measurements are made against that background did I understand that correctly?

Trying to keep this simple

Dave
NR1DX


On 8/3/2019 3:28 PM, K4SAV wrote:
There is growing trend on 160 that I find disturbing and that is for major DXpedition to use FT8 for all or mostly all 160 operations. They do that because they "know" that FT8 is ideally suited for weak signal operation.  They have read that and are continually told that by everyone.  Rare countries on 160 is synonymous with weak signals and poor signal to noise ratios.

I know of no one that has done the same tests that I posted to Topband.  I have had people agree with me but that was because they liked my answers, not because it agreed with their measurements.  I have had many people tell me I am wrong and they sited the official documentation as proof that my measurement were wrong.

So if you would like to join the ranks of myth busters, start doing some measuring.  WARNING, Myth busting of all types in ham radio is a never ending effort.  As soon as you bust one, two posts later someone will repeat it again. Sorry, I don't have any caps, pins, or t-shirts to sell.

If enough people start characterizing this mode maybe the more experienced people in radio will sit up and take notice.  One or two posts by a single person isn't going to do it.

You are not going to kill FT8 no matter what you do or how feel about it.  It will always be a home for those they can't copy CW, and for those that don't like CW, and for a few others for a variety of reasons.  I can't see a problem with that.  The problem I see is with FT8 and major DXpeditions.  I also see some FT8 only DXpeditions but those are usually vacation part time to non-rare countries.  Can't worry about those.

For people that can't copy CW, FT8 is very attractive.  It will allow them to work some DX on 160.  In the winter I see Europe appearing on FT8, so that can be worked from the eastern US. Invariably when I measure the strength of those stations, they are close to S6.  That would be arm chair copy on CW with a receiver that sits on S1 on noise.

So contribute to the ham radio knowledge data base by making some measurements.  I described my measurements in a previous post. Figuring out what the reported S/N number means is interesting but the more important question is what is the minimum signal to noise ratio this mode will decode.  Sitting up a test for minimum signal is a little tricky because there are so many FT8 stations on at any one time, there is almost never a nearly dead band.  I simulated that on 160 by waiting until the first stations from the NE showed up on the band (just after their sunset) and turning my antenna away from them so as to decrease their strength and bring up the noise from other directions.  When I wait until sunset occurs in more locations, my S meter hangs at about S9 +20 to 30 dB no matter which direction I point my antenna.  I tried doing this on 6 meters but often there was nothing there. I suggest doing measurement first in normal decoding mode, then test what it does in deep search mode.  Be careful how you switch modes.  FT8 likes to memorize the band and make guesses in deep search mode.

You can try doing the minimum S/N test in a crowded band instead of a nearly dead band but I don't think you will ever find it decoding a weak signal.  You have to measure the noise levels and signal levels.  You can't use the reported S/N number.

If you make some measurements, post them.  I would really like to hear what others find, especially if they happen to disagree with what I measured.

I don't have a pony in the dog and pony DXCC race so I don't have an opinion there.  I love working DX on 160 but collecting cards was no fun.  So years ago I decided to only do the fun part.  I compete with myself, no one else, and I don't get bragging rights, but I don't do this for bragging rights.

Jerry, K4SAV
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector


--
Dave
Manuals@ArtekManuals.com
www.ArtekManuals.com


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus

_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector

<Prev in Thread] Current Thread [Next in Thread>