The advice we were given from Hi-Z for a new 4 square was not more
elevation difference between elements than ~4 feet. ~20% of element
length. The topography that happens between elements, eg spanning a
creek, might not matter much given the simple single ground rod ground
per element, but haven't tried that.
Since a DHDL is elevated and is not ground connected it could be tilted
in a model to see what happens.
Grant KZ1W
On 1/12/2021 13:07, Fred Moeves wrote:
Jim,
Thank you very much.
And I can confirm that even short (300') Beverages work on slopes.
I do have one question please will loops like the VE3DO,DHDL and others
work on a slope?
73
Fred KB4QZH
On 1/12/2021 3:45 PM, Jim Brown wrote:
On 1/12/2021 11:14 AM, Fred Moeves wrote:
The property is on a slope that dumps into a creek then back up
another slope.
I don't think a 4 square would work i these conditions.
I was surprised how well the short Beverages worked out.
Both I and NI6T, a great engineer and topband op, have Beverages over
VERY irregular sloped terrain, and they work just fine. Both of us are
in dense redwood forests, where a 4-square is totally impractical.
Mine are 500 ft and 550 ft, reversible using DX Eng hardware.
73, Jim K9YC
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband
Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
_________________
Searchable Archives: http://www.contesting.com/_topband - Topband Reflector
|