In a message dated 96-11-06 01:58:41 EST, you write:
<< However, I have been tought that nothing in a ground path
should be soldered - everything should be clamped only. >>
This is a good rule if the solder is intended to replace the mechanical bond
for that joint... where the connectors are properly crimped and mechanically
secure and the solder is present only to improve the electrical connection
and prevent corrosion entering the joint, then soldering is acceptable...
Denny k8do@aol.com
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: K7LXC@contesting.com
Sponsored by Akorn Access, Inc & KM9P
|