Yes. It's almost identical in size to the old one but I think it has a
stainless shaft. Kinda wierd since they are both about 15 bucks and the
Bourns clearly appears to be a superior product. I would call Carl at TIC and
get the exact model number, but if you have the Digikey catalog, I think it's
fairly obvious which one you want. Gearing should not be affected. Just take
the gear off the old one and put it back on the new. When you put it
together, be sure to approximately center the new pot just in case you get the
wiring wrong and the pot wants to go the wrong way.
73, Ty K3MM
-----Original Message-----
From: Barry Kutner <w2up@itw.com>
To: Tyler Stewart <k3mm@erols.com>
To: <towertalk@contesting.com>
Date: Saturday, May 23, 1998 12:41
Subject: Re: [TowerTalk] TIC RIngrotor indicator problem
On 23 May 98, Tyler Stewart <k3mm@erols.com> wrote:
> It's the ten turn pot in the motor assy. He used to use a Clarostat (it's a
> black case) and now uses a blue Bourns pot that is supposed to be somewhat
> water resistant. Both are available in the Digikey catalog.
>
> 500 ohm, 10 turn, 1/4" shaft...
>
> 73, ty K3MM
>
Tnx info Ty. It's the same size, so no change in gearing, etc?
73 Barry
--
Barry Kutner, W2UP Internet: w2up@itw.com
Newtown, PA FRC alternate: barry@w2up.wells.com
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|