Hi Kevin,
It has been over 5 years now, but I ran into the same sticky
situation. I think common kerosene did the job (lamp oil), or
lighter fluid, paint thinner of some kind, maybe even goof off.
Had to be something handy, because I did not make any special
trips to get something special.
73 Jim K7SLI
> I managed to obtain some 3/4" CATV hardline with which I
> plan to feed a new
> horizontal loop. In preparing to install connectors, I
> discovered that
> underneath the outer black jacket, there is some VERY
> sticky adhesive
> between the aluminum shield and the black jacket. Is
> there something I can
> use to clean off this adhesive? It makes putting on
> connectors very messy.
>
> Thanks,
> Kevin.
> ------------------------------------------------------
> Kevin Hemsley
> Systems Engineer
> Microserv Computer Technologies, Inc.
> kev@ida.net
> KB7TYA
>
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|