Towertalk
[Top] [All Lists]

Re: [TowerTalk] Roller Inductors

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Roller Inductors
From: zl1aih@ihug.co.nz
Date: Fri, 16 Mar 2007 19:49:36 +1300
List-post: <mailto:towertalk@contesting.com>
> I recently returned to the air after an eight year absence.  The 
> roller inductors in my Nye MB-V-A and my Ten Tec 4229 antenna tuners 
> have corroded and are intermittent.  I have squirted contact cleaner 
> on the coils and rollers and run the rollers back and forth with no 
> improvement.  Does anyone have any suggestions?
> 73, Hank, W6SX
> Mammoth Lakes, California 



The RCA manual for their AT3 transmitter (WW2) recommended a mixture of 
anhydrous lanolin and carbon tetrachloride as a lubricant for the roller 
carriages.
I still have some anhydrous lanolin but carbon tet is no longer available in NZ.

My local chemist ('drugstore' in US) sold me a small bottle of 
trichloroethylene after 
strict examination and sure information from the RCA manual revealed that my 
intentions were entirely legal.
   
This mixture works very well - one of these big roller inductors (edge-wound) 
is in 
daily use in a "C-L-C" antenna tuner and has not needed any maintenance during 
three years of serious CW contesting - not bad for 1942 manufacture.   

I salvaged several roller inductors and big Hammond variable capacitors from 
the 
AT3 - all were covered in dust, gunge and mould.   While the XYL was away 
visiting 
her mother, I put them all through the dishwasher - ceramic end-plates came out 
pristine white and the metal looked brand-new.

73, Ken ZL1AIH (one of the ZM1A Team)







    

    

      
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>