I think that din plug was for a computer interface which was sold by
Yaesu as an optional extra. I think it was quite expensive as well.
Julio, W4HY
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Barrie Smith
Sent: Wednesday, November 07, 2007 4:21 PM
To: TowerTalk List
Subject: [TowerTalk] Yaesy elevation rotator
I'm about to install a G-5500 elevation rotor, which I have used in the
past, with good luck except for the small analog meter-readout.
The meter is (with my eyes) difficult to read accurately, and is
calibrated in 7.5 degree increments.
There is a DIN socket on the back of the controller which is labeled
"External Control", but not a mention of that in the manual.
I Googled the subject, and got about a million hits, but nothing that I
could use.
Anyone aware of how to externally control this unit? Or, at least, use
a large digital readout?
73, Barrie, W7ALW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|