I'm about to install a G-5500 elevation rotor, which I have used in the past,
with good luck except for the small analog meter-readout.
The meter is (with my eyes) difficult to read accurately, and is calibrated in
7.5 degree increments.
There is a DIN socket on the back of the controller which is labeled "External
Control", but not a mention of that in the manual.
I Googled the subject, and got about a million hits, but nothing that I could
use.
Anyone aware of how to externally control this unit? Or, at least, use a large
digital readout?
73, Barrie, W7ALW
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|