Using my previous paper for marking a cut line, remove paper from tubing ande
flatten it out making a crease in the paper. Each crease is 180 degrees from
the other. result a NO measurement method of finding opposing holes for drill
in round stock material. Just slide the pper back over the tubing and mark the
tubing at the crease. All this takes is paper, some Scotch tape, and a pencil.
For small tubing a "PORTA-LIGN fixture on a hand drill will provide a good thru
hole. Used this method to make 4X14el 2M yagis and 8X16el 432MHz yagis.
Arne N7KA
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|