Peter...
For the coaxial cable products that we produce we use a 1200 watt heat gun.
The key is to use adhesive heat shrink and make sure you have heated the
heat shrink to the point that the adhesive runs out the ends of the heat shrink.
This will give you a proper moisture seal.
Larry - WA5WWH
I understand that it is good practice to use shrink tubing to cover the barrel
of a crimp-on coax connector. What wattage heat gun will do a proper job of
shrinking the 3/4 inch tubing covering the RG-213 connector's barrel?
73 & Happy 2008!
Peter, AE1T
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|