Pete:
I did almost the same thing on my tower with the rotator control cable.
Underneath the rotator shelf and just before the cable enters a steel box at
the base of the tower, I formed a four-turn solenoid out of the cable and
held it in place with cable ties.
I did a similar thing with the coax runs at the bottom of the tower. I
formed them into two-turn loops before they also entered the steel box where
I have the antenna switch. I figure it's belts-and-suspenders for lightning
protection. It may not be very effective but it's free.
73 de
Gene Smar AD3F
----- Original Message -----
From: "Pete Smith" <n4zr@contesting.com>
To: <TowerTalk@contesting.com>
Sent: Thursday, May 27, 2010 8:09 AM
Subject: [TowerTalk] Lightning suppression through coax loops
>
>
> 73, Pete N4ZR
>
> The World Contest Station Database, updated daily at
> www.conteststations.com
> The Reverse Beacon Network at http://reversebeacon.net, blog at
> reversebeacon.blogspot.com
> I bought an Ameritron RCS-10 antenna switch at Dayton, and in reading
> the manual (please, no giggling) I note that it calls for a two-turn
> loop in each antenna coax line just before entering the relay box.
> These are described as "drip and lightning retarding loops." The manual
> is quite prescriptive (for example, "keep coils spaced from each other
> by vertical or horizontal separation of 2" minimum"), and I get the
> "drip" part, but I wonder what the real, practical effect of these loops
> would be. Is there enough inductance to offer any practical blocking
> effect for induced voltages resulting from a nearby strike?
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|