What brand and coax type would be best to use on a stack of VHF UHF Yagis 6
meters through 1296 for the rotator loop when transitioning from 1/2 inch hard
line?
On Sep 18, 2013, at 12:55 PM, Wayne Kline <w3ea@hotmail.com> wrote:
> Hi Gary
> There are many ways to skin a cat. My way with a flat top with there TB 3
> thrust bearing and there protruding bolts and sharp edge, is to transition
> any hardline connectors below the top plate ( A good place to test the
> antenna and feed line from also )
> then put the RG 231, 214 inside a reinforced 3/4" piece of garden hose. I
> install the antenna in the north position 1/2 it's rotation
> and wind 2 turns one laying on the flat top and one taped 6 to 8" above
> the flat plate. most of these install's are in the snow and ice of Eastern
> PA NJ NY or Dell and to the best of my knowledge there was never a frayed,
> tore coax with this type of configuration.
>
> Like said said there just another way to
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|