25G and 45G use two different sizes at each joint on each leg. I forget what
size they are offhand. DX Engineering sells leg bolts and their web site may
tell you what the sizes are or the perhaps the Rohn web site.
73, Larry W6NWS
-----Original Message-----
From: Cal Zethmayr
Sent: Wednesday, May 07, 2014 12:02 AM
To: towertalk@contesting.com
Subject: [TowerTalk] ROHN TOWER BOLTS
There is quite a debate at one of our local Saturday morning breakfasts
gabfests about Rohn Tower Bolts.
Some say that Rohn uses two different size bolt sets for each tower section.
Some say that Rohn uses only one size bolt-washer-nut sets for all towers.
So what are the facts?
Are there different size bolt sets for Rohn towers, and are they different
depending on the tower ? 25G, 45G and 55G?
Cal Z
W4GMH in Crestview, FL.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|